Avaya 9608 Administrator's Manual page 52

Server Administration
Parameter
ICMPRED
L2Q
L2QVLAN
LOGLOCAL
MCIPADD
NDREDV6
PHY1STAT
PHY2STAT
PROCPSWD
PROCSTAT
REREGISTER
REUSETIME
SIG
SNMPADD
SNMPSTRING
STATIC
TLSDIR
TLSPORT
TLSSRVR
Administering 9608/9608G/9611G/9621G/9641G IP Deskphones H.323
52
Description
Controls whether ICMP Redirect messages are processed. The default is 0 which
redirects messages that are not processed.
specifies the 802.1Q tagging mode. The default is 0 which signifies automatic.
VLAN ID of the voice VLAN. The default is 0.
Controls the severity level of events logged in the SNMP MIB. The default is 7.
CM servers IP addresses or DNS names. If there are too many addresses or names
to include all of them in the DHCP site-specific option, include at least one from
each major system. Then set MCIPADD again in the 46xxsettings.txt file with the
complete list of addresses. Providing a subset of the addresses through DHCP
improves reliability if the file server is not available due to server or network
problems.
NDREDV6 IPv6 only. Controls whether IPv6 Neighbor Discovery Redirect
messages will be processed.
Controls the Ethernet line interface speed. The default is 1 which indicates that it is
auto-negotiate.
Controls the secondary Ethernet interface speed. The default is 1 which indicates
that it is auto-negotiate.
Security string used to access local procedures. The default is 27238 (CRAFT).
Controls whether local Craft procedures are allowed. The default is 0 which
indicates that access to all administrative options is allowed.
The number of minutes the phone waits before and between re-registration
attempts.
The n umber of seconds to wait for successful completion of DHCP before reusing
previous parameters on the default (port) VLAN. The default is 60.
The signaling protocol download flag that indicates which protocol applies (H.323
(1), SIP, (2) or Default (0). For software releases prior to 6.0, SIG can only be set
manually on the deskphone and not through DHCP or in the 46xxsettings.txt file.
Default means the default protocol supported at that location. A custom upgrade file
is required to support both protocols. For software releases 6.0 and later, separate
upgrade files with different names are used for H.323 and SIP, and Default means
to download the upgrade file for the same protocol that is supported by the software
that the deskphone is currently using.
Allowable source IP addresses for SNMP queries. The default is " " (Null).
SNMP community name string. The default is " " (Null).
Controls whether to use a manually-programmed file server or CM IP address
instead of those received through DHCP or a settings file. If a manually
programmed file server IP address is to be used, STATIC must be set through
DHCP.
Specifies the path name prepended to all file names used in HTTPS GET
operations during startup.
Specifies the TCP port number for HTTPS file downloading.
Specifies the IP addresses or DNS names of Avaya file servers to download
configuration files.
Comments? infodev@avaya.com
June 2014