Avaya 9608 Administrator's Manual page 76

Administering Deskphone Options
Parameter name
DOT1X
DOT1XEAPS
DOT1XSTAT
DOT1XWAIT
DROPCLEAR
ENHDIALSTAT
FBONCASCREEN
GRATARP
Administering 9608/9608G/9611G/9621G/9641G IP Deskphones H.323
76
Default value Description and value range
0 802.1X Supplicant operation mode. Valid values are: 0=
With PAE pass-through, 1= with PAE pass-through and
proxy Logoff, 2=without PAE pass-through or proxy Logoff.
For more information, see
page 98.
MD5 Specifies the EAP method used for 802.1X operation.
Valid values are MD5 and TLS .
0 Determines how the deskphone handles Supplicants. Valid
values are: 0= Supplicant operation is completely disabled.
1=Supplicant operation is enabled, but responds only to
received unicast EAPOL messages. 2 = Supplicant
operation is enabled and responds to received unicast and
multicast EAPOL messages. For more information, see
About IEEE 802.1X
0 Specifies whether the telephone will wait for 802.1X
authentication to complete before initiating DHCP
Valid values, 0 and 1
If DOT1XWAIT = "0" when the 802.1X Supplicant is
started, startup will continue without waiting for 802.1X
authentication to complete, =1 Startup will not continue.,
1 VPN only. Specifies how clear IPsec packets are
processed. One ASCII numeric digit. Valid values are: 0=
all other packets will be processed, but not by IPsec, or
1=all other packets will be discarded.
1 Enhanced Dialing Status. If set to 1, the Administering
dialing methods feature is turned on for all associated
applications. For more information, see
dialing methods
turned off.
0 Specifies whether the Feature buttons are displayed on
the same screen as Call Appearance when the value of
PHNSCRALL is 0. Applies only to 9608, 9608G, and
9611G deskphones.
• 0: Deskphone does not display Feature buttons on the
Call Appearance screen.
• 1: Deskphone displays Feature buttons that can adjust
on the Call Appearance screen. In addition, the
deskphone has a separate screen for Features.
0 Gratuitous ARP flag. Controls whether the deskphone
processes gratuitous ARPS or ignores them.
If you use Processor Ethernet (PE) duplication and if your
phones are on the same subnet as the PE interfaces, set
this parameter to 1, to allow the fastest failover to the new
PE interface.
Comments? infodev@avaya.com
About IEEE 802.1X
on page 98.
Administering
on page 106. If set to 0, the feature is
on
June 2014