Avaya 9608 Administrator's Manual page 101

These phones:
• do not support LLDP on the secondary Ethernet interface.
• do not forward frames received with the 802.1AB LLDP group multicast address as the
destination MAC address between the Ethernet line interface and the secondary Ethernet
interface.
The 9600 Series IP deskphone initiates LLDP after receiving an LLDPDU message from an
appropriate system. After the phone is initiated, the phone sends an LLDPDU every 30 seconds or
as specified by LLDP_XMIT_SECS parameter with the following contents:
Table 11: LLDPDU transmitted by the phones
Category
Basic Mandatory
Basic Mandatory
Basic Mandatory
Basic Optional
Basic Optional
Basic Optional
IEEE 802.3
Organization Specific
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
June 2014
TLV Name (Type)
Chassis ID
Port ID
Time-To-Live
System Name
System Capabilities
Management Address
MAC / PHY
Configuration / Status
LLDP-MED Capabilities
Extended
Power-Via-MDI
Network Policy
Inventory – Hardware
Revision
Inventory – Firmware
Revision
Inventory – Software
Revision
Administering 9608/9608G/9611G/9621G/9641G IP Deskphones H.323
Comments? infodev@avaya.com
About Link Layer Discovery Protocol (LLDP)
TLV Info String (Value)
IPv4 IP Address of phone.
MAC address of the phone.
120 seconds.
The Host Name sent to the DHCP server in DHCP
option 12.
Bit 2 (Bridge) is set in the System Capabilities if the
phone has an internal Ethernet switch. If Bit 2 is set in
Enabled Capabilities then the secondary port is
enabled.
Bit 5 (phone) in the System Capabilities. If Bit 5 is set
in the Enabled Capabilities than the phone is
registered.
Mgmt IPv4 IP Address of phone.
Interface number subtype = 3 (system port). Interface
number = 1.
OID = SNMP MIB-II sysObjectID of the phone.
Reports auto-negotiation status and speed of the
uplink port on the phone.
Media Endpoint Discovery - Class III - IP Telephone.
Power Value = 0 if the phone is not currently powered
through PoE, else the maximum power usage of the
deskphone plus all modules and adjuncts powered by
the phone in tenths of a watt.
Tagging Yes/No, VLAN ID for voice, L2 Priority, DSCP
Value.
MODEL - Full Model Name.
BOOTNAME, or for phones running Software Release
6.0 or later, Firmware Revision = RFSINUSE.
APPNAME, or for phones running Software Release
6.0 or later, Software Revision = APPINUSE.
101