Administering Settings At The Phone - Avaya 9608 Administrator's Manual

Administering Deskphone Options
System Parameter
Name

Administering settings at the phone

Installing and maintaining Avaya IP Deskphone 9608, 9608G, 9611G, 9621G, and 9641G H.323
describes how to use Craft local procedures at the phone for administration. The local procedures
you might use as an administrator are:
• 802.1x - Enable or disable the Supplicant and the Pass-thru options.
• ADDR - Add the IP addresses for the call server, HTTP server, HTTPS server, and other
network related parameters.
• CLEAR - Remove all administered values, user-specified data, option settings, etc. and return
a phone to the phone's initial "out of the box" default values.
• DEBUG - Enable or disable debug mode for the button module serial port.
• GROUP - Set the group identifier on a per-phone basis.
• HSEQUAL - Administer the HAC related parameters.
• INT - Set or change the interface control value(s) of PHY1STAT and/or PHY2STAT.
• RESET - Reset the deskphone to default values including any values administered through
local procedures, and the values previously downloaded using DHCP or a settings file.
• RESTART - Restart the deskphone in response to an error condition, including the option to
reset parameter values.
• SSON - To add site specific options.
• Test - To run a self test on the phone.
• VIEW - Review the 9600 IP deskphone system parameters to verify the current parameter
values and file versions.
Note:
If you have not changed the default password, the Debug option is available in a Read-Only
mode.
Administering 9608/9608G/9611G/9621G/9641G IP Deskphones H.323
104
TLV Name
Extended Power-Via-
MDI
Comments? infodev@avaya.com
Impact
Power conservation mode is enabled if the received binary
Power Source value is 10, and power conservation mode is
disabled if the received binary Power Source value is not
10. Power conservation mode is enabled even if the phone
is not powered over Ethernet because the phone sends
information about the power source that it is using in a TIA
LLDP MED Extended Power-Via-MDI TLV. The power
management system intends to conserve local power also.
June 2014