Badge Rotation; Rotating Driver - Martin Audio CDD-LIVE! Series User Manual

CDD‐LIVE
Repeat this process for the remaining gaps in the grille to ease it out of the slot all the way up one side of the cabinet; when you
get to the final gap the grill should pop out and away from the front of the cabinet.
To replace the grille, first insert one side into the slot on one side of the cabinet. Make sure the return on the grille is completely
engaged in the slot. Push on the front of the grille with the flat of your hand, which will encourage the other edge of the grille to
locate on the side of the cabinet close to the slot. Now push the edge of the grille back starting at the top or the bottom to
engage the return in the slot; you may need to do this a little at a time, working down the length of the grille until it pops into
place.
BADGE ROTATION
The badge can also easily be rotated to match the orientation of the cabinet. The fixing point is spring loaded so it is simply a
case of pulling the badge slightly forward and rotating it to the required position.
ROTATING DRIVER
With the grille removed the driver mounting screws are accessible. There are four screws for the CDD‐Live 8 and four for the
CDD‐Live 12 and eight for the CDD‐Live 15. The screws are hex head, the Hex key sizes are as follows;‐

CDD‐Live 8

CDD‐Live 12

CDD‐Live 15
Fully unscrew all mounting screws, the driver can be carefully raised using a small flat‐blade screwdriver inserted into the recess
at the bottom of the cabinet
CDD‐LIVE User Guide V1.0
USER GUIDE
5mm
5mm
6mm
25