CDD‐LIVE
Quick Start
CDD‐Live can be set up extremely quickly and easily using a standard analogue audio connection and selecting the correct preset.
This diagram shows the wiring for a basic system;‐
To configure the system, these are the necessary steps;‐
1.
Connect a mains cable from a nearby mains outlet to the PowerCon True1 mains inlet on all CDD‐Live cabinets. (See
the chapter on wiring PowerCon True1 cables for more details) Do not yet turn on power at the socket.
2.
Connect an XLR Cable from our audio source; mixer or similar into the CSX‐Live sub if used. One cable will be required
for left and another for right for a stereo speaker array. If a subwoofer is not used connect straight to the CDD‐Live
cabinet.
3.
Connect a short XLR cable from each CSX Sub to the corresponding CDD‐Live cabinet.
4.
Turn on your mixing console
5.
Turn on your CDD‐Live speakers
6.
Select the correct Preset on the back of the CSX and CDD‐Live speakers as follows;‐
CDD‐Live 8, 12, 15 full range (no subwoofer)
CDD‐Live 8, 12, 15 with Subwoofer
CDD‐Live 8, 12, 15 stage monitor mode (see chapter on rotating driver)
CSX‐Live 118, 218 with CDD‐Live 12, 15
CSX‐Live 118, 218 with CDD‐Live 8
CDD‐LIVE User Guide V1.0
USER GUIDE
Preset 1
Preset 2
Preset 3
Preset 1
Preset 2
9