Page 2
UNPACKING The C115 is packed in pairs complete with wall brackets. Each Martin C115 is built to the highest standard and thoroughly tested before it leaves the factory. After unpacking the speakers and brackets, examine them carefully for any signs of transit damage and inform your dealer if any such damage is found.
C115 is to be used with a significant downward tilt. NEAR-CORNER MOUNTING The wall-bracket supplied can be used to mount the C115 close to a corner if required rather than using the optional dedicated corner mount. Typical distances of the centre of the bracket from the corner to allow for downward tilt angles of 0, 10, and 20 degrees are shown below.
The wires should be stripped to approximately 8-10mm. It is important that all the C115’s in a distributed system are wired in phase i.e. consistent polarity is maintained throughout. Each C115 is wired so that a positive voltage on the RED terminal causes forward motion of the speaker cone.