Zones - Martin Audio CDD-LIVE! Series User Manual

CDD‐LIVE
Parameters can be changed on the properties panel in three ways. The faders can be drag and dropped to a new value, the value
can be scrolled up or down using the up/down buttons to the right of the value windows, and finally values can be directly typed
into the value windows. The response graph will adjust according to the new values and vice versa, adjustments in the graph
window will be reflected in the fader positions and values in the properties panel.
To summarise, there are four ways to adjust filter parameters;‐
1. Click and drag on the graph
2. Click and drag the properties faders
3. Use the up/down value buttons in the properties section
4. Directly type values into the value boxes.
Whilst this might seem over‐versatility, it is intended to offer several options to suit the way that the system is being operated.
If adjustments are being made with using a wireless tablet PC with a stylus whilst walking around a venue, certain options may
be easier to use than if you were sitting at a desk with a mouse plugged in to the PC.
Zones
Any cabinet can be a member of any (or none) of the twenty zones available which are labelled A to T which will gang together
all parameters for every cabinet in the zone. Note that all gain and delay parameters are offset ganged. If there is already a value
entered before adding a CDD‐Live cabinet to a zone this will be retained and subsequent changes to a value for any gain or delay
to any cabinet in the same zone will increase or decrease all values according to any edits you make but will retain the offset
between all values. To select a zone click on the Zone button at the top of the Overview page;‐
CDD‐LIVE User Guide V1.0
USER GUIDE
51