Ssh Authentication Mode And Algorithm Settings - D-Link xStack DGS-3600 User Manual

Parameter
SSH Server Status
Max Session (1-8)
Time Out (120-600)
Auth. Fail (2-20)
Session Rekeying

SSH Authentication Mode and Algorithm Settings

The SSH Algorithm window allows the
configuration of the desired types of SSH
algorithms used for
encryption. There are four categories of
algorithms listed and specific algorithms of
each may be enabled or disabled by using
their corresponding pull-down menus. All
algorithms are enabled by default. To open
the following window, click Security >
SSH > SSH Authentication Mode and
Algorithm Settings:
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Description
Use the pull-down menu to enable or disable SSH on the Switch. The default is Disabled.
Enter a value between 1 and 8 to set the number of users that may simultaneously access the
Switch. The default setting is 8.
Allows the user to set the connection timeout. The use may set a time between 120 and 600
seconds. The default setting is 120 seconds.
Allows the Administrator to set the maximum number of attempts that a user may try to log on
to the SSH Server utilizing the SSH authentication. After the maximum number of attempts
has been exceeded, the Switch will be disconnected and the user must reconnect to the
Switch to attempt another login. The number of maximum attempts may be set between 2 and
20. The default setting is 2.
Using the pull-down menu uses this field to set the time period that the Switch will change the
security shell encryptions. The available options are Never, 10 min, 30 min, and 60 min. The
default setting is Never.
authentication
Figure 11- 47. Encryption Algorithm window
234