Web-Based Switch Configuration; Introduction; Login To Web Manager; Web-Based User Interface - D-Link xStack DGS-3600 User Manual

Web-based Switch Configuration

Introduction

Login to Web manager

Web-Based User Interface

Web Pages
Introduction
All software functions of the Switch can be managed, configured and monitored via the embedded web-based (HTML) interface.
The Switch can be managed from remote stations anywhere on the network through a standard browser such as Opera, Netscape
Navigator/Communicator, or Microsoft Internet Explorer. The browser acts as a universal access tool and can communicate
directly with the Switch using the HTTP protocol.
The Web-based management module and the Console program (and Telnet) are different ways to access the same internal
switching software and configure it. Thus, all settings encountered in web-based management are the same as those found in the
console program.
Login to Web Manager
To begin managing the Switch, simply run the browser you have installed on your computer and point it to the IP address you
have defined for the device. The URL in the address bar should read something like: http://123.123.123.123, where the numbers
123 represent the IP address of the Switch.
This opens the management module's user authentication window, as seen below.
Leave both the User Name field and the Password field blank and click OK. This will open the Web-based user interface. The
Switch management features available in the web-based manager are explained below.
Web-based User Interface
The user interface provides access to various Switch configuration and management screens, allows you to view performance
statistics, and permits you to graphically monitor the system status.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
NOTE: The Factory default IP address for the Switch is 10.90.90.90.
Figure 5- 1. Enter Network Password window
Section 5
22