D-Link xStack DGS-3600 User Manual page 66

Auth-Protocol
Priv-Protocol
To return to the SNMP User Table, click the
Table Configuration window, click on the Add button on the SNMP User Table window. This will open the SNMP User Table
Configuration window, as shown below.
The following parameters can set:
Parameter
User Name
Group Name
SNMP Version
Auth-Protocol
Priv-Protocol
Encrypted
To implement changes made, click Apply. To return to the SNMP User Table, click the
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
None - Indicates that no authorization protocol is in use.
MD5 - Indicates that the HMAC-MD5-96 authentication level will be used.
SHA - Indicates that the HMAC-SHA authentication protocol will be used.
None - Indicates that no authorization protocol is in use.
DES - Indicates that DES 56-bit encryption is in use based on the CBC-DES (DES-56)
standard.
Show All SNMP User Table Entries
Figure 6- 28. SNMP User Table Configuration window
Description
Enter an alphanumeric string of up to 32 characters. This is used to identify the SNMP user.
This name is used to specify the SNMP group created can request SNMP messages.
V1 - Specifies that SNMP version 1 will be used.
V2 - Specifies that SNMP version 2 will be used.
V3 - Specifies that SNMP version 3 will be used.
MD5 - Specifies that the HMAC-MD5-96 authentication level will be used. This field is only
operable when V3 is selected in the SNMP Version field and the Encryption field has been
checked. This field will require the user to enter a password.
SHA - Specifies that the HMAC-SHA authentication protocol will be used. This field is only
operable when V3 is selected in the SNMP Version field and the Encryption field has been
checked. This field will require the user to enter a password.
None - Specifies that no authorization protocol is in use.
DES - Specifies that DES 56-bit encryption is in use, based on the CBC-DES (DES-56)
standard. This field is only operable when V3 is selected in the SNMP Version field and the
Encryption field has been checked. This field will require the user to enter a password
between 8 and 16 alphanumeric characters.
Checking the corresponding box will enable encryption for SNMP V3 and is only operable in
SNMP V3 mode.
link. To add a new entry to the SNMP User
Show All SNMP User Table Entries
50
link.