Static Ipv6 Arp Settings - D-Link xStack DGS-3600 User Manual

Static IPv6 ARP Settings

Static ARP entries can be defined for IPv6 addresses. This will create a permanent entry is entered and is used to translate IPv6
address to MAC addresses.
To open the Static IPv6 ARP Table open the Administration folder, and then open the Static ARP folder and click on the
Static IPv6 ARP Settings link.
To remove an entry, click the Delete button for the entry being removed. To completely clear the Static IPv6 ARP Settings, click
the Clear All button. To add a new entry, click the Add button, revealing the following screen to configure:
The following fields can be set or viewed:
Parameter Description
IPv6 Address The IPv6 address of the ARP entry. Specify the address using the format as IPv6 Address
(IPv6 Address is hexadecimal number, for example 1234::5D7F/32).
MAC Address The MAC address of the IPv6 ARP entry.
After entering the IPv6 Address and MAC Address of the Static IPv6 ARP entry, click Apply to implement the new entry.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 8- 15. Static IPv6 ARP Settings table
Figure 8- 16. Static IPv6 ARP Settings – Add menu
121