D-Link xStack DGS-3600 User Manual page 209

Parameter
Profile ID (1-5)
Type
Offset
Click Apply to implement changes made.
To establish the rule for a previously created CPU Access Profile:
In the ACL folder, click CPU Interface Filtering to open the CPU Interface Filtering Profile Table.
In this window, the user may add a rule to a previously created CPU access profile by clicking the corresponding Add Rule
button of the entry to configure Ethernet, IP or Packet Content Mask.
Click the Add Rule button to continue on to the CPU Interface Filtering Rule Table window. A new and unique window, for
Ethernet, IP and Packet Content will open as shown in the examples below.
To change a rule for a previously created CPU Access Profile Rule:
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Description
Type in a unique identifier number for this profile set. This value can be set from 1 - 5.
Select profile based on Ethernet (MAC Address), IP address or Packet Content Mask. This
will change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
•
header.
Select IP to instruct the Switch to examine the IP address in each frame's
•
header.
Select Packet Content Mask to specify a mask to hide the content of the packet
•
header.
This field will instruct the Switch to mask the packet header beginning with the offset value
specified:
value (0-15) – Enter a value in hex form to mask the packet from the beginning
•
of the packet to the 15th byte.
value (16-31) – Enter a value in hex form to mask the packet from byte 16 to
•
byte 31.
value (32-47) – Enter a value in hex form to mask the packet from byte 32 to
•
byte 47.
value (48-63) – Enter a value in hex form to mask the packet from byte 48 to
•
byte 63.
value (64-79) – Enter a value in hex form to mask the packet from byte 64 to
•
byte 79.
Figure 10- 21. CPU Interface Filtering Profile Table - Add
Figure 10- 22. CPU Interface Filtering Rule Table
193