D-Link xStack DGS-3600 User Manual page 128

Enter a name for the new interface to be added in the Interface Name field (if you are editing an IP interface, the Interface Name
will already be in the top field as seen in the window above). Enter the interface's IP address and subnet mask in the
corresponding fields. Pull the State pull-down menu to Enabled and click Apply to enter to make the IP interface effective. To
view entries in the IP Interface Table, click the
enter the changes into NV-RAM.
The following fields can be set:
Parameter
Interface Name
IP Address
Subnet Mask
VLAN Name
Secondary
State
Link Status
Click Apply to implement changes made.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 8- 2. IP Interface Settings – Add
Figure 8- 3. IP Interface Settings - Edit
Show All IP Interface Entries
Description
This field displays the name for the IP interface. The default IP interface is named "System".
This field allows the entry of an IP address to be assigned to this IP interface.
This field allows the entry of a subnet mask to be applied to this IP interface.
This field allows the entry of the VLAN Name for the VLAN the IP interface belongs to.
Use the pull-down menu to set the IP interface as True or False. True will set the interface
as secondary and False will denote the interface as the primary interface of the VLAN
entered above. Secondary interfaces can only be configured if a primary interface is first
configured.
This field may be altered between Enabled and Disabled using the pull down menu. This
entry determines whether the interface will be active or not.
This read only field states the current status of the IP Interface on the Switch. Link Up
denotes that the IP interface is up and running on the Switch. Link Down will denote that the
IP interface is not currently set and/or enabled on the Switch.
hyperlink. Use the Save Changes dialog box to
112