Acl; Access Profile Table - D-Link xStack DGS-3600 User Manual

ACL

Access Profile Table

CPU Interface Filtering
Access profiles allow users to establish criteria to determine whether or not the Switch will forward packets based on the
information contained in each packet's header. These criteria can be specified on a basis of Packet Content, MAC address, or IP
address.
Access Profile Table
Creating an access profile is divided into two basic parts. The first is to specify which part or parts of a frame the Switch will
examine, such as the MAC source address or the IP destination address. The second part is entering the criteria the Switch will use
to determine what to do with the frame. The entire process is described below in two parts. To display the currently configured
Access Profiles on the Switch, open the ACL folder and click the Access Profile Table link. This will open the Access Profile
Table page, as shown below.
To add an entry to the Access Profile Table, click the Add Profile button. This will open the Access Profile Configuration page,
as shown below. There are three Access Profile Configuration pages; one for Ethernet (or MAC address-based) profile
configuration, one for IP address-based profile configuration, and one for IPv6 addresses. Users can switch between the three
Access Profile Configuration pages by using the Type drop-down menu. The page shown below is the Ethernet Access Profile
Configuration page.
The following parameters can be set, for the Ethernet type:
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 10- 1. Access Profile Table
Figure 10- 2. Access Profile Table (Ethernet)
Section 10
178