When You Cannot Make Copies As Wanted - Ricoh Aficio MP W3600 Operating Instructions Manual

When You Cannot Make Copies As
Wanted
This section explains likely causes of and possible solutions for unclear copies.
❖ Basic
Problem
Misfeeds occur frequently. The number of sheets
Misfeeds occur frequently. The cut paper tray's side
Misfeeds occur frequently. The paper is damp.
Misfeeds occur frequently. The paper is too thick or
Misfeeds occur frequently. The paper is folded or
Misfeeds occur frequently. Jammed or torn paper is
Misfeeds occur frequently. The paper is curled.
Misfeeds occur frequently. Printed paper is being
Copy paper becomes
creased.
Copy paper becomes
creased.
Copy paper becomes
creased.
Copies are slanted.
Original and copy size
does not match.
Cause
loaded in the cut paper
tray exceeds the capacity
of the machine.
fences are set too tightly.
too thin.
creased.
inside the machine.
used.
The paper is damp.
The paper is damp.
The paper is too thin.
The original was not set
straightly.
Dampness can cause pa-
per to stretch.

When You Cannot Make Copies As Wanted

Solution
Load paper only as high as the upper
limit markings on the side fences of the
cut paper tray. See p.57 "Loading Pa-
per".
Push the cut paper tray's side fences
slightly apart, and then reset the tray.
Use paper that has been stored in the
recommended temperature and humid-
ity condition. See "Copy Paper", About
This Machine.
Use recommended paper. See "Copy
Paper", About This Machine.
Cut folded or wrinkled areas off the pa-
per roll.
Remove cut paper that is folded or wrinkled.
Remove the paper properly. See p.67
"Removing Jammed Paper".
Smooth out the curl and try again.
Use recommended paper. Do not use
paper that has been already copied or
printed onto. See "Copy Paper", About
This Machine.
Replace the paper with new paper. Cut
the paper to 1000 mm (40") just before
copying.
Turn on the anti-humidity heater
switch. See "Anti-humidity Heater
Switch", About This Machine.
Use recommended paper. See "Copy
Paper", About This Machine.
Set the original so that it is squarely
aligned with the original guides.
Adjust the Fine Magnification setting for
Additional Copy. See "Fine Magnifica-
tion", Copy/Document Server Reference.
2
23