Housing; Power On Your Prestige; Figure 2-3 Power-On Display For Dss1 Switch - ZyXEL Communications P-202 User Manual

Prestige 201 ISDN Access Router
VT100 terminal emulation.
9600 Baud.
No parity, 8 Data bits, 1 Stop bit.
Flow Control set to None.
After the Prestige is properly set up, you can make future changes to the configuration through telnet
connections.
2.4

Housing

Your Prestige's housing has ventilation slots for cooling and clip-out legs that fit snugly into grooves for
sturdy stacking with better airflow. ZyXEL recommends that you do not stack more than 4 routers for
maximum stack stability and cooling.
2.5

Power On Your Prestige

At this point, you should have connected the console port, the ISDN BRI port, the Ethernet port and the
power port to the appropriate devices or lines. You can now apply power to the Prestige by flipping the
power switch to on (I is ON, O is OFF).
Step 1. Initial Screen
When you power on your Prestige, it performs several internal tests as well as line initialization. After the
initialization, the Prestige asks you to press [ENTER] to continue, as shown.
Copyright (c) 1994 - 2000 ZyXEL Communications Corp.
initialize ch =0, ethernet address: 00:a0:c5:ff:aa:01
(2) DSS1:
Press ENTER to continue...
Step 2. Entering Password
The login screen appears after you press Enter, prompting you to enter the password, as shown below.
For your first login, enter the default password 1234. As you type the password, the screen displays a (X)
for each character you type.
Hardware Installation & Initial Setup

Figure 2-3 Power-On Display for DSS1 switch

2-3