Activating operation of the sunshade
Read and observe
and
If the operation of sunshade is deactivated (e.g. after disconnecting and con-
necting the battery), then the operation will have to be activated.
›
Switch on the ignition, press and hold the
The sunshade opens and closes again after around 10 seconds.
›
Release the button.
on page 61 first.
» Fig. 44
on page 62 button.
Lights and visibility
Lights
Introduction
This chapter contains information on the following subjects:
Unless otherwise stated, the lights only work when the ignition is switched on.
WARNING
The automatic driving lamp control only operates as a support and
does not release the driver from his responsibility to check the lights and, if
necessary, to switch on the light depending on the prevailing light condi-
tions.
Note
The headlights may mist up temporarily. When the light is switched on, the
light-emitting surface demists after a short period of time.
64
64
65
65
66
66
67
67
67
67
68
68
63
Lights and visibility