Removable Light - Skoda SUPERB Owner's Manual

Using the storage compartments - variant 1
›
Lift the flooring via loop in the direction of arrow
A
fold back or fasten using the loop on the hook on the luggage compartment
cover.
›
Stow the cargo in the storage compartments.
›
Fold back the flooring against the direction of the arrow or remove it from
the hook.
When transporting tall objects in the compartments, the flooring must be fol-
ded forward.
Using the storage compartments - variant 2
›
Dividing the luggage compartment with variable loading floor
›
Lift the floor covering in the direction of arrow
on the upper edge of the variable loading floor.
C
›
Stow the cargo in the storage compartments.
›
Unhook hook and fold back the flooring against the direction of the arrow
C
(fold back the variable loading floor to the initial position if necessary).
When transporting tall objects in the compartments, the hook
hooked onto the upper edge of the variable loading floor.
CAUTION
Before closing the boot lid check that the flooring is not attached to the
■
hook with the loop » Fig. 131 - there is a risk of damaging the hook.
A
Before closing the boot lid, check that the cargo transported in the storage
■
compartments does not strike against the luggage compartment cover - there
is a risk of damage to the lid.

Removable light

» Fig. 131 and completely
» page 107.
» Fig. 132 and hook into hook
must be
C
Fig. 133
Removable lamp
Fig. 134 Removable light: removing / inserting

Read and observe and
The light is located on the left side of the luggage compartment and is used to
light the luggage compartment or as a portable light.
The lamp is fitted with magnets. As a result, this can, for example, be fitted to
the vehicle body.
Description of the light » Fig. 133
Button to turn on / off the light
A
Part that lights up when the lamp is in the mount
B
Part that lights up when the lamp is not in the mount
C
If the light is in the mount, this will illuminate when the boot lid is opened.
›
To remove, hold the light in the area
» Fig. 134.
1
›
To switch on the removed light, press button
again will switched it off.
›
To insert, first of all insert the light with the rear part
» Fig. 134 and then push the light in the direction of arrow
clicks into place.
If the light is not switched off and is correctly inserted in the mount, the LED
diodes in the front part of the light
If the lamp is not correctly inserted into the holder, this does not light up when
the boot lid is opened and the rechargeable batteries are not charged.
Lamp charges
The lamp is supplied by three rechargeable type NiMH AAA batteries. The bat-
teries are charged continuously with the engine running (to fully charge the
battery takes approximately 3 hours).
on page 98 first.
and swivel in the direction of arrow
D
» Fig. 133. Pressing the light
A
into the mount
E
until it audibly
2
» Fig. 133 are automatically switched off.
C
Transport of cargo

105