Skoda SUPERB Owner's Manual page 111

Fig. 140 Correctly secure net partition behind the front seats in the
pulled-out state
The net partition can either be pulled out and secured from behind the rear
seats or behind the front seats.
Pull out and secure the net partition behind the rear seats
›
Fold out part of the roll-up luggage compartment cover in the direction of
A
arrow » Fig. 139.
›
Pull out the net partition at the crossbar
and push forwards » Fig. 140.
D
›
Insert the crossbar on the other side of the vehicle in the mounting
same way.
›
Make sure that the crossbar is firmly seated in the two mountings
›
Fold back part of the roll-up luggage compartment cover in the opposite
A
direction of the arrow » Fig. 139.
Using the net partition behind the rear seats
›
Fold out part of the roll-up luggage compartment cover in the direction of
A
arrow » Fig. 139.
›
First pull the crossbar back slightly on the one side and then on the other
side and remove it from the mountings
›
Hold the crossbar in such a way that the net partition can slowly roll up
C
without being damaged.
›
Fold back part of the roll-up luggage compartment cover in the opposite
A
direction of the arrow » Fig. 139.
108
Using the system
, insert in one of the mountings
C
in the
D
.
D
» Fig. 140.
D
Pull out and secure the net partition behind the front seats
The process is analogous to that for behind the rear seats. Before removing
the net partition, the rear seat backrests should be folded forwards. After roll-
ing up the net partition in the housing, the rear seat backrests should then be
folded back » page 80.
CAUTION
If the net partition blocks when pulling it out, push the release lever
direction of the arrow » Fig. 139.
Removing and installing the net partition housing
›
To remove, fold forwarded the rear seat backrests and open the rear right
door.
›
Push the housing in the direction of the arrow
A
mountings in the direction of the arrow
›
To install, insert the recesses on the housing
rear seat backrests and push the housing against the arrow
stop.
›
Fold the rear seat backrests to their original position.
in the
B
Fig. 141
Removing the net partition
housing
and remove it from the
1
» Fig. 141.
2
into the mountings on the
A
up to the
1