Inserting
›
Slide the plug in the opposite direction of the arrow
light. The locks on the plug must be inserted securely.
›
Insert the light with the openings
fully press in the
light»
.
›
Screw the tail lamp into place and install the cover. The cover must engage
securely.
CAUTION
Ensure that when inserting the light the wiring harness between the body
■
and the light is not jammed and the seal
inserted - there is a risk of water ingress and damage to the electrical installa-
tion.
Ensure that the vehicle paintwork and the tail lamp are not damaged when
■
removing and installing the rear light.
Replacing the bulbs in the rear light
Fig. 266 Tail light / bulb replacement
Read and observe
and
›
Turn the holder with the bulb
A
.
1
›
Remove the socket with the bulb from the lamp housing in the direction of
arrow
.
2
›
Push the faulty bulb into the holder, turn in anti -clockwise direction up to
the stop and remove.
›
Insert a new bulb into the holder and turn in a clockwise direction to the
stop.
›
Reinsert the holder with the bulb into the lamp housing and turn in the op-
posite direction of the arrow
1
» Fig. 265
4
onto the studs
in the body and care-
D
C
» Fig. 266
on page 217 is correctly
C
on page 214 first.
or
» Fig. 266
in the direction of the arrow
B
to the stop.
into the
217
Fuses and light bulbs