Tyre Pressure Monitoring; Fig - Skoda SUPERB Owner's Manual

Note
In some situations, the system may evaluate the driving incorrectly and thus
■
mistakenly recommend a break (e.g. sporty driving, adverse weather condi-
tions or poor road conditions).
The system is designed primarily for use on motorways.
■
Function

Read and observe on page 163 first.
From the starting of the journey, the system evaluates the steering behaviour
at speeds 65-200 km/h. If, while driving, there have been changes in the steer-
ing behaviours that are evaluated by the system as indicating possible fatigue,
a break recommendation is issued.
Conditions under which a break from driving is detected by the system
▶
The vehicle is stopped and the ignition switched off.
▶
The vehicle is stopped, the seat belt removed and the driver's door opened.
▶
The vehicle is stopped for more than 15 minutes.
If none of these conditions are met or if the driving style is not changed, the
system recommends a driving break again after 15 minutes.
The system can be activated/deactivated in the Infotainment
ual - Infotainment.
Pause recommendation
The icon appears and the following message for a few seconds in the display
of the instrument cluster  and a message about the detected fatigue. An au-
dible signal is also emitted.

Tyre pressure monitoring


Introduction
This chapter contains information on the following subjects:
Storing the tyre pressure values and Infotainment display
The tyre pressure monitoring function (following known as system) monitors
the tyre pressure while driving.
If the tyre inflation pressure changes, the warning light
strument cluster and an audible signal is
164
Driving
» Owner´s Man-
lights up in the in-

heard» page 35, Tyre pressure.
The system can only function properly if the tyres have the prescribed inflation
pressure and these pressure values are stored in the system.
WARNING
Please take note of the general points relating to the use of assistance
■
systems » page 128,
Having the correct tyre inflation pressure is always the driver's responsi-
■
bility. Tyre pressure should be checked regularly
The system cannot warn in case of very rapid tyre inflation pressure loss,
■
e.g. in case of sudden tyre damage.
Storing the tyre pressure values and Infotainment display

Read and observe
Procedure for storing the tyre pressure values
›
Inflate all the tyres to the specified pressure.
›
Turn on the ignition and switch on Infotainment.
›
Press the button in Infotainment and then tap on the  Tap → Vehicle

status.
›
Use the function surfaces   Select the menu item Tyre Pressure Loss Indi-
cator.
›
Tap the function   surface
In addition, follow the instructions that appear on the display.
164
A message in the display informs about the storage of the tyre pressure val-
ues.
Always save the tyre pressure values in the system if one of the following
events occurs.
▶
Change of tyre pressure values.
▶
Change one or more wheels.
in section Introduction.
» page

Fig. 206

Button for storing the pressure
values / example of the display:
the system includes a tyre pres-
sure change front left
on page 164 first.
» Fig. 206.
192.
