Fitting
›
First, insert the front mounting
cess
» Fig.
122.
D
›
Press on the two sides on the upper side of the cover in the area of the re-
cess
. The mountings
and
D
B
sides of the luggage compartment.
›
On both sides of the boot lid unhook the straps
WARNING
During the trip there must be no objects on the cover - risk of injury in the
event of sudden braking or a vehicle collision!
CAUTION
Observe the following instructions to avoid canting and the subsequent
■
damage to the cover or the side trim.
The cover must be inserted properly and the load must not exceed the
■
height of the cover.
The cover must not be jammed in the surrounding seal of the luggage com-
■
partment lid when it is in the raised position.
There must be no object in the gap between the cover in the raise position
■
and the rear backrest.
Never fold the raised cover forwards to the rear seats - there is a risk of dam-
■
aging the cover and the boot lid.
and then the rear mounting
B
C
must engage with the recess
C
.
A
Roll-up cover
in the re-
on both
D
Fig. 124 Roll-up cover: pull out / roll up / intermediate position / remove
Fig. 125 Remove the left side cover / store roll-up cover
Read and observe
Extending
›
Grasp the cover at grip-point
until it audibly clicks into
1
and
on page 98 first.
and pull it out in the direction of the arrow
A
place» Fig.
124.
Transport of cargo
101