Skoda SUPERB Owner's Manual page 204

Description of puncture repair kit
Fig. 236 Description of puncture repair kit

Read and observe on page 200 first.
The kit is located in a box under the floor covering in the luggage compart-
ment.
Sticker with speed designation "max. 80 km/h"/"max. 50 mph"
1
Valve remover
2
Inflation hose with plug
3
Air compressor
4
Button for the tyre pressure reduction
5
12 volt cable connector
6
Tyre inflation hose
7
Tyre inflation pressure indicator
8
ON and OFF switch
9
Tyre inflation bottle with sealing agent
10
Replacement valve core
11
Note
The declaration of conformity is included with the air compressor or the log
folder.
Preparing to use the puncture repair kit

Read and observe on page 200 first.
For safety's sake, the following instructions must be observed before
performing a wheel repair the road.
›
As far as possible, park the vehicle far away from the traffic flow - find a
place with a flat and firm surface.
›
Switch off the engine.
›
For vehicles with manual transmission, select 1st gear.
›
For vehicles with automatic transmission, place the selector lever in the P
position.
›
Switch on the parking brake.
›
Position the hazard warning system and the warning triangle at the prescri-
bed distance.
›
All the occupants should get out of the vehicle. The passengers should not
stand on the road (instead they should remain behind a crash barrier, for in-
stance) while the wheel is being repaired.
›
Uncouple any trailers.
Sealing and inflating tyres

Read and observe on page 200 first.
Sealing
›
Unscrew the valve cap from the damaged tyre.
›
Insert the valve remover » Fig. 236
2
that the valve insert fits into the slot of the valve remover.
›
Unscrew the valve insert and lay it on a clean surface (e.g. cloth, paper etc.).
›
Forcefully shake the tyre inflater bottle
times.
›
Firmly screw the inflation hose
the cap is pierced automatically.
›
Remove the plug from the inflation hose
the tyre valve.
›
Hold the bottle with the bottom facing upwards and fill all of the sealing
10
agent from the tyre inflator bottle into the tyre.
›
Remove the filler plug from the tyre valve.
›
Screw in the valve insert using the valve remover
on page 201 on the valve insert, so
» Fig. 236 on page 201 several
10
onto the tyre inflater bottle
3
10
and plug the open end fully onto
3
.
2
Emergency equipment and self-help
. The film on

201