Start control
›
Press the button
» Fig. 194
on page 150 button.
›
or: set the lever in the sprung
The ACC takes the current driving speed and performs the control, the warning
light
illuminates in the instrument cluster.
If the control is started by moving the lever to the position and should
the speed be stored already, the ACC adopts this speed and executes control.
Note
If control is started at a speed of less than 30 km/h on vehicles with an auto-
matic transmission, the speed of 30 km/h is stored. The speed increases auto-
matically to 30 km/h or is regulated with respect to the speed of the vehicle
ahead.
Stop/resume control
Read and observe
on page 148 first.
Stop control
›
Set the lever into the sprung position
›
or: apply the brake.
Control stops, the speed remains stored.
Resume control
›
Start control
» page
150, Start control.
Note
Control is also stopped when the clutch pedal is held down for longer than 30
s or the TCS is deactivated.
Set/change the desired speed
Read and observe
on page 148 first.
The desired speed can be set or changed using the control lever
page 150.
Setting/changing the speed by increments of 10 km/h at a time () - re-
quirements
The ACC is activated.
» Fig. 194
on page 150 position.
» Fig. 194
on page 150 position.
» Fig. 194
Increasing/reducing the speed by increments of 1 km/h at a time (/-
requirements
The ACC is activated.
Vehicle control takes place.
Changing the speed by adopting the current speed () - requirements
The ACC is activated.
The vehicle is moving at a speed other than that which is stored.
Note
If during control the speed is increased by pressing the accelerator, control is
■
temporarily stopped. Upon releasing the accelerator, control is automatically
resumed.
If during control the speed is reduced by applying the brake, control is stop-
■
ped. Control needs to be restarted in order to resume
If the vehicle is controlled by a lower speed than the stored speed, then
■
the current speed is stored by pressing the button again and the speed is
reduced in increments of 1 km/h.
Set the clearance level
Read and observe
The proximity to the vehicle ahead can be set with the lever
page 150 or in the Infotainment
Setting by means of the lever
›
Set the switch to the sprung position or
The display of the instrument cluster shows line
which indicates the proximity.
›
Using the switch on the lever, adjust the line
tance.
Note
on
If the proximity is changed in infotainment, the change will only come into
■
effect after a subsequent activation of the ACC.
The higher the speed, the greater the proximity to the vehicle ahead.
■
The adjustment of the distance is stored (depending on the Infotainment
■
type) in the active user account personalisation
» page
on page 148 first.
»
Owner´s Manual - Infotainment.
» Fig. 194
» Fig. 192
2
to the desired dis-
2
» page
46.
Assist systems
150.
» Fig. 194
on
on page 150.
on page 149,
151