Skoda SUPERB Owner's Manual page 202

Anti-theft wheel bolts
The anti-theft wheel bolts protect the wheels from theft. The upper section
» Fig. 232 must be used to loosen/tighten these.
›
Insert the upper section » Fig. 232
B
stops.
›
Insert the wrench on the attachment
wheel bolt.
›
Removing the upper section.
The upper section for the anti-theft wheel bolts must always be kept in the
vehicle in preparation for a possible wheel change.
With wheel trims supplied at the factory or from ŠKODA Original Accessories,
the position of the anti-theft wheel bolt is marked on the back of the wheel
trim » page 198.
Note
The upper section and the anti-theft wheel bolts are provided with a code
number. This is used to obtain a replacement upper piece from the ŠKODA
Genuine Accessories.
Fig. 232
Anti-theft wheel bolt and upper
section
on the anti-theft wheel bolt until it
A
until it stops and loose/tighten the
B
Loosening/tightening wheel bolts
›
Push the wheel wrench onto the wheel bolt to the stop. Use the associated
B
upper section for the anti-theft wheel bolts
›
To loosen the screws, hold the wrench end and turn the screw about one
turn in the direction of arrow
›
To tighten the screws, hold the wrench end and turn the screw against the
direction of the arrow » Fig.
WARNING
If it proves difficult to undo the bolts, carefully apply pressure to the end of
the wrench with your foot. Keep hold of the vehicle when doing so, and
make sure you keep your footing - risk of accident.
Raising the vehicle
Fig. 233
Loosening the wheel bolts
» Fig. 232 on page 199.
» Fig. 233.
233, until it is tight.
Fig. 234
Jacking points for the jack
Emergency equipment and self-help

199