Stop/resume control
Read and observe
on page 154 first.
Stop control
›
Set the lever into the sprung position
Or
›
Apply the brake.
Control stops, the speed remains stored.
Resume control
›
Start control
» page
157.
WARNING
Control may only be resumed if the stored speed is not too high for the cur-
rent traffic conditions.
Note
Regulation is also stopped when the clutch is held down for longer than 30 s.
Set/change the desired speed
Read and observe
on page 154 first.
The desired speed can be set or changed using the control lever
page 157.
The set speed is stored upon releasing the lever or the button on the button
on the lever.
Setting/changing the speed by 10 km/h at a time () - requirements
The ACC is activated.
Increasing the speed by 1 km/h at a time () - requirements
The ACC is activated.
Vehicle control taking place.
Decreasing the speed by 1 km/h at a time () - requirements
The ACC is activated.
Vehicle control taking place.
158
Driving
» Fig. 186
on page 157 .
» Fig. 186
on
Changing the speed by adopting the current speed () - requirements
The ACC is activated.
The vehicle is moving at a speed other than that which is stored.
Note
If during control the speed is increased by pressing the accelerator, control is
■
temporarily stopped. Upon releasing the accelerator, control is automatically
resumed.
If during control the speed is reduced by applying the brake, control is stop-
■
ped. Control needs to be restarted in order to resume
If the vehicle is controlled by a lower speed than the stored speed, then
■
the current speed is stored the first time the button is pressed. Press the but-
ton again and the speed is reduced in increments of 1 km/h.
Set the clearance level
Read and observe
on page 154 first.
The proximity to the vehicle ahead can be set with the lever
page 157 or in the Infotainment
»
ter CAR - Vehicle settings.
Setting by means of the lever
›
Set the switch in the spring-tensioned position
» Fig. 186
on page 157.
The display of the instrument cluster shows line
which indicates the proximity.
›
Using the switch on the lever, adjust line
level.
Note
If the proximity is changed in infotainment, the change will only come into
■
effect after a subsequent activation of the ACC.
The proximity is dependent on the speed. The higher the speed, the greater
■
the proximity to the vehicle ahead.
On wet roads, a longer time interval to the vehicle ahead should always be
■
selected than on dry roads.
» page
157.
» Fig. 186
Operating instructions Infotainment, chap-
or
adjust
-
» Fig. 184
on page 156,
2
to the desired distance
2
on