Remote Control - Skoda Rapid 2013 Owner's Manual

Hide thumbs Also See for Rapid 2013:
Table of Contents

Advertisement

Insert the flipped-out key bit into the recess and turn the vehicle key in the di-
rection away from the vehicle
» fig.
Reinstall the rubber seal and close the door completely.
Check that the door is locked.
Repeat for the other doors as necessary.
Have the vehicle checked immediately by a specialist garage.
Notice
Doors can be unlocked and opened from the inside by pulling the door opening
lever. If necessary, the door opening lever must be pulled twice

Remote control

Introductory information
You can use the remote control key:
To unlock and lock the vehicle.
To unlock or open the boot lid.
The transmitter with the battery is housed in the handle of the remote control
key. The receiver is located in the interior of the vehicle. The operating range of
the remote control key is approx. 30 m. But this range of the remote control can
be reduced if the batteries are weak.
The key has a fold-open key bit which can be used for unlocking and locking the
car manually and also for starting the engine.
If a lost key is replaced or if the receiver unit has been repaired or replaced, the
system must be initialised by a ŠKODA Service Partner. Only then can the remote
control key be used again.
20
Using the system
10.
» page
18.
Unlocking and locking car
Fig. 11 Key without remote control / Remote control key
Function
Action with the buttons
in the vehicle key
- 
Unlocking
Press the button
the vehicle
Press and hold for con-
venience opening.
Locking
Press the button
the vehicle
and hold for convenience
closing.
Unlocking
Press the button
the boot
lid
The remote control key locks and unlocks the vehicle only if the batteries have
sufficient power and the vehicle key is in the range of a few metres around the
vehicle.
When locking the vehicle, all turn signal lights will flash once for confirmation.
When unlocking the vehicle, all turn signal lights will flash twice for confirma-
tion.
If the turn signal lights do not flash for confirmation, at least one of the doors or
the boot lid or bonnet is not locked.
Action with the vehicle key in the lock
» fig. 11
cylinder or with a mechanical vehicle
key
» fig. 11
- 
.
Insert vehicle key into lock cylinder of
the driver's door and turn clockwise.
Turn and hold for convenience opening.
. Press
Insert vehicle key into lock cylinder of
the driver's door and turn counter-
clockwise. Turn and hold for conven-
ience closing.
.
Insert vehicle key into lock cylinder of
the boot lid and turn clockwise.

Advertisement

Table of Contents
loading

Table of Contents