Behringer DEEPMIND 12 User Manual page 62

62 DeepMind 12 User Manual
P.MOD-SRC - This option allows you to select the source for the amount of PITCH
MODULATION from the following:
• • LFO-1 - Bipolar use of the LFO 1 waveform.
• • LFO-2 - Bipolar use of the LFO 2 waveform.
OSC 2 PITCH MODULATION AMOUNT (LFO AS SOURCE)
OSC 2
LFO (SIN)
PITCH MOD LOW
PITCH MOD MED
PITCH MOD HIGH
There is also a visualization of the modulation as shown below. The arrows
indicate the polarity of the modulation..
• • ENV-1 - Bipolar use of the ENV 1 envelope.
• • ENV-2 - Bipolar use of the ENV 2 envelope.
• • ENV-3 - Bipolar use of the ENV 3 envelope.
OSC 2 PITCH MODULATION AMOUNT (ENVELOPE AS SOURCE)
OSC 1 (SQR)
ATTACK DECAY
ENVELOPE
PITCH MOD
Note: In the visualization for ENVELOPE sources the arrow will only point in the
UP direction indicating that the modulation will be positive from the base pitch.
RELEASE
SUSTAIN
• • LFO-1(Uni) - Unipolar use of the LFO 1 waveform.
• • LFO-2(Uni) - Unipolar use of the LFO 1 waveform.
Note: In any of the Unipolar (Uni) modes the waveform is only used for positive
modulation.
OSC 2 PITCH MODULATION (UNIPOLAR LFO AS SOURCE)
OSC 1 (SQR)
LFO (SIN)
UNIPOLAR
PITCH MOD
The default setting for the P.MOD-SRC is LFO-1.
Note: In the visualization for Uni-polar LFO sources the arrow will only point in
the UP direction indicating that the modulation will be positive from the base
pitch.
The default setting for the P.MOD-SRC is LFO-1.
AFT>P.MOD - This option controls how much PITCH MODULATION is increased
by AFTERTOUCH pressure. This allows you to expressively control the PITCH
MODULATION and its eff ect using key pressure.
The AFT>P.MOD range is from 0-255, and the default setting is 0 (Off ).
WHEEL>P.MOD -This option controls how much PITCH MODULATION depth is
increased by the MOD WHEEL position. This allows you to expressively control the
PITCH MODULATION and its eff ect using the MOD WHEEL.
The MOD WHEEL>P.MOD range is from 0-255, and the default setting is 0 (Off ).
T.MOD-SRC - This option allows you to select the source for the amount of TONE
MODULATION from the following:
• • MANUAL - In this mode the TONE MOD fader is used to manually adjust the
PWM.
• • LFO-1 - Bipolar use of the LFO 1 waveform. In this mode the TONE MOD fader
is used to adjust the amount of modulation from 0 to +/- 49%.
• • LFO-2 - Bipolar use of the LFO 2 waveform. In this mode the TONE MOD fader
is used to adjust the amount of modulation from 0 to +/- 49%.
OSC 2 TONE MODULATION (LFO AS SOURCE)
OSC 2 (SQR)
LFO (SIN)
TONE MOD