Short-Cuts; Menu Parameter Reset; Osc Modulation Sources; Vcf Lfo Source - Behringer DEEPMIND 12 User Manual

102 DeepMind 12 User Manual

10. Short-cuts

In order to speed up programming tasks there are several short-cuts
implemented on the DeepMind 12 as listed below.
Note: While holding down any of the shortcut switches the menu will
momentarily switch to the relevant menu. Once you release the shortcut switch
you will be returned to the PROG screen.

10.1 Menu Parameter Reset

To reset any menu parameter to its default setting momentarily press the -NO
and+YES switches at the same time.
10.2 LFO 1 Shape
To change the LFO 1 waveform shape press and hold the LFO 1 EDIT switch. While
holding the switch you can use the LFO 1 RATE fader to set the LFO 1 waveform
shape. The following message will be shown to give you guidance while holding
the LFO 1 EDIT switch.
10.3 LFO 2 Shape
To change the LFO 2 waveform shape press and hold the LFO 2 EDIT switch. While
holding the switch you can use the LFO 2 RATE fader to set the LFO 2 waveform
shape. The following message will be shown to give you guidance while holding
the LFO 2 EDIT switch.

10.4 OSC Modulation Sources

To change any of the OSC Modulation sources press and hold the OSC EDIT switch.
While holding the switch you can use any of the following faders to set the
source for the respective parameter:
• • OSC 1 PITCH MOD
OSC 1 PWM
• •
• • OSC 2 PITCH MOD
• • OSC 2 TONE MOD
The following message will be shown to give you guidance while holding the OSC
EDIT switch

10.5 VCF LFO Source

To change the VCF LFO source press and hold the VCF EDIT switch. While holding
the switch you can use the VCF LFO fader to select the source LFO. The following
message will be shown to give you guidance while holding the LFO 1 EDIT switch.
10.6 MOD MATRIX Bus Confi guration
Each MOD MATRIX bus can be confi gured without having to scroll through the
large lists of sources and destinations. In order to do this please use the following
steps:
1) Use the navigation switches to select and of the parameters on the bus
you would like to confi gure.
2) Press and hold the MOD switch
3) To select a modulation source press an edit switch (further presses will
cycle though the options associated with the switch), or press any key
on the keyboard to cycle through the sources associated with notes.
4) To select a modulation destination move the fader of the required
parameter.
5) To set the modulation depth adjust the data entry fader.
Once you have confi gured the bus as you require you can release the
MOD MATRIX switch.
Note: All changes will immediately have an eff ect so that you can hear the
changes to your program by the modulation bus.