Behringer DEEPMIND 12 User Manual page 131

Hide thumbs Also See for DEEPMIND 12:
Table of Contents

Advertisement

131 DeepMind 12 User Manual
Meter: Visual device to indicate the level of a signal.
MIDI (Musical Instrument Digital Interface) (A technical standard that
describes a protocol, digital interface and connectors and allows a wide variety of
electronic musical instruments, computers and other related hardware/software
devices to connect and communicate.
MIDI Clock A clock signal which is broadcast over MIDI to ensure that devices are
synchronised. Also known as MIDI Beat Clock or MIDI Timing Clock.
MIDI Message Data or information transmitted from one MIDI device to another.
Each MIDI message contains at least two numbers: one that identifi es the type of
message being sent, and another which represents a value for the selected type
of message.
Midrange Frequencies in a signal ranging from 250 Hz to 5 kHz (Approximately
B3 to D#8).
Mix The balance of level between one signal and another.
Mixer A device that blends input signals into composite signals for output.
Modular synthesis A synthesis system comprised of a number of modules which
can be connected in many diff erent ways. Modules can perform a single function
such as an oscillator or fi lter or perform multiple functions.
Modulation The process of controlling one or more properties (destinations) of a
signal using another signal (source).
Modulation Matrix: A matrix which allows the creation of multiple source to
destination modulations, each with adjustable levels of operation.
Modulation Wheel (Mod Wheel) A wheel located to the left of a keyboard that
allows you to change specifi ed parameters in real-time.
Monitors: Studio quality loudspeakers, providing an accurate representation of
the audio signals.
Mono: A single signal.
Monophonic Only one note can be played at any given time as there is only a
single voice.
Mute Function that allows a signal to be silenced.
N/A Abbreviation for "not applicable".
Noise Generator A circuit or process that produces a random (or aperiodic)
signal. The frequency response can diff er depending on the type of noise.
Note-Priority Determines which note is played when several are held
simultaneously.
Non-Registered Parameter Number (NRPN) A series of controller change
messages used to transmit a parameter change with up to 14-bits of resolution.
Octave or Oct Unit of measurement for pitch. Every time the frequency of a
waveform doubles, the pitch increases by one octave.
Ohm (Ω) Unit of electrical resistance.
Oscillator An electronic device which generates a periodic signal used to form
the basis of a synthesizer program.
One Shot A single event that has to be triggered each it is required.
Output The signal sent out by a device or process. Also used to describe the
physical socket where a signal leaves a device.
Overtone Any frequency that is present in a waveform that is higher than the
fundamental frequency of that waveform.
Pad A program that is usually characterized by slow attack and release times.
Panning / Pan The positioning of a signal within a stereo image.
Parameter: A setting whose value can be changed.
Parametric EQ A type of EQ that allows all of the parameters of equalisation to
be changed, including centre frequency, boost/cut in gain and bandwidth.
Partial Any of the sinusoidal waveforms which form part of a complex tone.
Patch The cables used on modular synthesizers (or synthesizers with modular
compatibility) to connect devices together. Patch cables can carry audio, gate or
control voltage signals.
Period The time that it takes a wave to complete a full cycle. Period is calculated
by dividing 1 by the frequency
Phase: A measurement (in degrees) of the time diff erence between
two waveforms or between a single waveform and a reference point.
Phaser An eff ect which uses a series of notched all-pass fi lters (also called
stages) to create a comb fi lter response which does not always have harmonic
relationships between the notches. The result is a sweeping eff ect similar to a
fl anger but smoother and often more natural sounding.
Pink Noise A type of signal that has equal power in each band. Human hearing is
roughly logarithmic, therefore each octave is discerned to have an equal amount
of power across the audible spectrum.
Pitch: A quality of sound that makes is possible to judge if a sound is higher or
lower than another.
Pitch Bend / Pitch Bend Wheel Controlling the pitch of a note after it has been
played.
Pitch shift Alteration of pitch or frequency, but without adjusting tempo.
Pole A section of a fi lter stage. The more poles a fi lter has, the steeper its
attenuation slope will be, and the more accurate the fi lter will be.
Polyphonic Capable of playing more than one note at once.
Polyphony The number of notes a polyphonic synthesizer can play
simultaneously.
Portamento An adjustable performance eff ect that glides or bends the pitch
from one note to the next.
Post The point for accessing audio just after it leaves a specifi c component or
stage.
Pre The point for accessing audio just before it reaches a specifi c component or
stage.
Preset: A program or part of a program that is built into a synthesizer patches
that are sometimes fi xed and sometimes editable.
Program A complete set of parameters and settings which the synthesizer uses
to create the a specifi c sound.
Power Supply Unit (PSU) The component in a system which is responsible for
supplying and managing power.
Psychoacoustics The study of the perception of sound, that is, how we
listen, our psychological responses and the physiological eff ects on the human
nervous system.
Pulse Wave Similar to a square wave, but without symmetry. Also known as a
"Rectangle Wave"
Pulse Width Modulation (PWM) Modulation of the pulse width (the duty
cycle of a pulse wave measured as a percentage). A pulse width of 50% has equal
positive and negative sections and is considered a square wave.
Q Factor A bandwidth (or selectivity), of a particular band in an equalizer. The
higher the Q Factor, the wider the bandwidth.
Rate The speed at which a particular device is operating at.
Release Time The fourth and fi nal stage of an ADSR envelope. Specifi ed as the
duration of time for an envelope to reach zero after the played key is released.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents