Behringer DEEPMIND 12 User Manual page 60

60 DeepMind 12 User Manual
P.MOD-SRC - This option allows you to select the source for the amount of PITCH
MODULATION from the following:
• • LFO-1 - Bipolar use of the LFO 1 waveform.
• • LFO-2 - Bipolar use of the LFO 2 waveform.
OSC 1 PITCH MODULATION (LFO AS SOURCE)
OSC 1 (SAW)
LFO (SIN)
PITCH MOD
OSC 1 (SQR)
LFO (SIN)
PITCH MOD
There is also a visualization of the modulation as shown below. The arrows
indicate the polarity of the modulation.
• • ENV-1 - Unipolar use of the ENV 1 envelope.
• • ENV-2 - Unipolar use of the ENV 2 envelope.
ENV-3 - Unipolar use of the ENV 3 envelope.
• •
OSC 1 PITCH MODULATION AMOUNT (ENVELOPE AS SOURCE)
OSC 1 (SQR)
ATTACK DECAY
ENVELOPE
PITCH MOD
Note: In the visualization for ENVELOPE sources the arrow will only point in the
UP direction indicating that the modulation will be positive from the base pitch.
RELEASE
SUSTAIN
• • LFO-1(Uni) - Unipolar use of the LFO 1 waveform.
• • LFO-2(Uni) - Unipolar use of the LFO 1 waveform.
Note: In any of the Unipolar (Uni) modes the waveform is only used for positive
modulation. This is useful when you want the note to play at the original
frequency and modulation uses that as a reference point (Unipolar), rather than
have the note modulated to positive and negative off sets (Bipolar).
OSC 1 PITCH MODULATION (BIPLOAR/UNIPOLAR LFO AS SOURCE)
OSC 1 (SAW)
LFO (SQR)
BIPOLAR
OSC 1 WITH
PITCH MOD
OSC 1 (SQR)
LFO (SQR)
UNIPOLAR
OSC 1 WITH
PITCH MOD
The default setting for the P.MOD-SRC is LFO-1.
Note: In the visualization for Uni-polar LFO sources the arrow will only point in
the UP direction indicating that the modulation will be positive from the base
pitch.
AFT>P.MOD - This option controls how much PITCH MODULATION is increased
by AFTERTOUCH pressure. This allows you to expressively control the PITCH
MODULATION and its eff ect using key pressure
The AFT>P.MOD range is from 0-255, and the default setting is 0 (Off ).
WHEEL>P.MOD -This option controls how much PITCH MODULATION depth is
increased by the MOD WHEEL position. This allows you to expressively control the
PITCH MODULATION and its eff ect using the MOD WHEEL.
The AFT>P.MOD range is from 0-255, and the default setting is 0 (Off ).
PWM-SRC - This option allows you to select the source for the amount of PULSE
WIDTH MODULATION from the following:
• • MANUAL - In this mode the PWM fader is used to manually adjust the PULSE
WIDTH.