Japanese Web-Based Access Control (Jwac) Commands - D-Link xStack Reference Manual

xStack
JAPANESE WEB-BASED ACCESS CONTROL (JWAC)
The Japanese Web-based Access Control (JWAC) commands in the Command Line Interface (CLI) are listed (along with
the appropriate parameters) in the following table.
Command
enable jwac
disable jwac
enable jwac redirect
disable jwac redirect
enable jwac forcible_logout
disable jwac forcible_logout
enable jwac udp_filtering
disable jwac udp_filtering
enable jwac
quarantine_server_monitor
disable jwac
quarantine_server_monitor
config jwac
quarantine_server_error_timeout
config jwac redirect
config jwac virtual_ip
config jwac quarantine_server_url
config jwac
clear_quarantine_server_url
config jwac update_server
config jwac switch_http_port
config jwac ports
config jwac radius_protocol
create jwac user
config jwac user
delete jwac
show jwac user
clear jwac auth_state
config jwac authorization attributes
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
<sec 5-300>
{destination [quarantine_server | jwac_login_page] | delay_time <sec 0-10>} (1)
<ipaddr> {url [<string 128> | clear]}
<string 128>
[add | delete] ipaddress <network_address> {[tcp_port < port_number 1-65535>
| udp_port < port_number 1-65535>]}
<tcp_port_number 1-65535> {[http | https]}
[<portlist> | all] {state [enable | disable] | max_authenticating_host <value 0-50> |
aging_time [infinite | <min 1-1440>] | idle_time [infinite | <min 1-1440>] |
block_time [<sec 0-300>] | auth_mode [host _based | port_based]} (1)
[local | pap | chap | ms_chap | ms_chapv2 | eap_md5]
<username 15> {vlan <vlanid 1-4094>}
<username 15> {vlan <vlanid 1-4094>}
[user <username 15> | all_users]
[ports [all | <portlist>] { authenticated | authenticating | blocked } | mac_addr
<macaddr>]
{radius [enable| disable] | local [enable | disable]} (1)
380
50
COMMANDS