Adjusting Flip Back Armrests - Invacare Arrow RWD Service Manual

SECTION 7—ARMS
Installing
1. Visually inspect to ensure flip back armrest release lever is in the unlocked
(horizontal) position.
2. Slide the flip back armrest into the arm sockets on the seat frame.
3. Install the quick release pin through the rear arm socket and flip back armrest.
4. Lock the flip back armrest by pressing the flip back armrest release lever into the
locked (vertical) position.
5. Repeat STEPS 1-4 for the opposite flip back armrest.
Removing
1. Unlock the flip back armrest by positioning the flip back armrest release lever into the
unlocked (horizontal) position.
2. Remove the quick release pin that secures the flip back armrest to the rear arm socket.
3. Pull up on the flip back armrest and remove the armrest from the arm sockets.
4. Repeat STEPS 1-3 for the opposite flip back armrest, if necessary.
Flip Back Armrest
FIGURE 7.2 Installing/Removing Flip Back Armrests

Adjusting Flip Back Armrests

Make sure the flip back armrest release and height adjustment levers are in the
locked position before using the wheelchair.
NOTE: For this procedure, refer to FIGURE 7.3 on page 59.
3G Storm Series® Wheelchairs
Rear
Arm
Socket
Quick Release
Pin
Flip Back Armrest Release Lever
WARNING
Seat
Frame
Front Arm Socket
58
Locked
(Vertical)
Unlocked
(Horizontal)
Part No. 1104849