Converting 22Nf Battery Box Tray To Group 24 Battery Box Sub-Frame Assembly - Invacare Arrow RWD Service Manual

Installing
1. Install battery tray onto base frame.
2. Secure the rear of the battery tray to battery mount brackets with existing locknuts.
Torque to 160 in-lbs (13.36 ft-lbs)(18.03 Nm).
3. Secure the front of the battery tray to the base frame with existing mounting screws
and locknuts. Torque to 160 in-lbs (13.36 ft-lbs)(18.03 Nm).
4. Reinstall the battery box. Refer to Removing/Installing Battery Boxes on page 121.
Locknuts
*Rubber
Element
*NOTE: Illustration depicts the rubber element. Battery Box Tray removes in
the same manner for shock assembly.
FIGURE 12.14 Removing/Installing 22NF Battery Box Tray
Converting 22NF Battery Box Tray to Group 24
Battery Box Sub-Frame Assembly
Removing 22NF Components
NOTE: For this procedure, refer to FIGURE 12.15 on page 128.
1. Remove the battery box. Refer to Removing/Installing Battery Boxes on page 121.
2. Remove the battery box tray. Refer to Removing/Installing Battery Boxes on page 121.
3. Remove the wiring harness. Refer to Removing/Installing the Wiring Harness on
page 131.
NOTE: The battery box tray and the battery mount brackets will not be reused. Mounting screws
and spacers will be reused.
4. Remove the four mounting screws that secure the battery mount brackets to the base
frame.
5. Remove the battery mount brackets.
Part No. 1104849
Battery Mount
Bolts
Bracket
Battery Tray
127
SECTION 12—BATTERIES
Base
Frame
Locknuts
3G Storm Series® Wheelchairs