Section 6-Arms; Installing/Removing/Positioning/Adjusting Flip Back Armrests; Installing; Removing - Invacare Pronto M71 Jr. with SureStep Owner's Operator And Maintenance Manual

SECTION 6—ARMS
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, verify that on/off switch
on the joystick is in the off position.
Installing/Removing/Positioning/Adjusting Flip Back
Armrests
Make sure the flip back armrest release and height adjustment levers are in the
locked position before using the wheelchair.
NOTE: For this procedure, refer to FIGURE 6.1 on page 44.
NOTE: Flip back armrest release lever must be in unlocked position when placing armrest into the
arm sockets.

Installing

1. Slide the flip back armrest into the arm sockets on the wheelchair frame.
2. Install the quick release pin through the rear arm socket and flip back armrest.
3. Lock flip back armrest by pressing flip back armrest release lever into the locked
(vertical) position.
4. Lift up on flip back armrest to make sure the armrest is locked in place.
5. Repeat STEPS 1-4 for opposite flip back armrest.

Removing

1. Unlock flip back armrest by pulling flip back armrest release lever into the unlocked
(horizontal) position.
2. Remove the quick release pin that secures the flip back armrest to the wheelchair
frame.
3. Pull up on the flip back armrest and remove the armrest from the arm sockets.
4. Repeat STEPS 1-3 for the opposite flip back armrest, if necessary.
Part No 1122147
WARNING
WARNING
43
SECTION 6—ARMS
® ™
Pronto M71 Jr. with SureStep
®