Invacare Arrow RWD Service Manual page 118

Table of Contents

Advertisement

SECTION 12—BATTERIES
The range per battery charge using recommended batteries should be approximately 5 to
9 hours of typical operation. Extensive use on inclines may substantially reduce per
charge mileage.
Description of Battery Chargers
The charger automatically reduces the charge from an initially high rate to a zero reading
at a fully charged condition. If left unattended, the charger should automatically shut-off
when full charge is obtained.
There are some basic concepts which will help you understand this automatic process.
They are:
The amount of electrical current drawn within a given time to charge a battery is called
the "charge rate". If, due to usage, the charge stored in the battery is low, the charge rate
is high, as indicated by the green light on the charger. Initially, the green light will stay
illuminated for a short period of time followed by a longer period of off time. As a charge
builds up, the charge rate is reduced, and the green light will stay illuminated for a longer
period of time followed by a shorter off time.
NEVER leave the charger unattended when the charger circuit breaker is tripping
ON and OFF. A condition between the battery charger and batteries exists. Con-
tact an Invacare dealer.
NOTE: If performing the charging procedures independently, READ and CAREFULLY follow the
individual instructions for each charger (supplied or purchased).
NOTE: If charging instructions are not supplied, consult a qualified service technician for proper
procedures.
Using Battery Chargers
1. Perform one of the following:
• WHEELCHAIRS EQUIPPED WITH MCC-MARK IV JOYSTICK - Attach the
battery charger connector to the charger cable/battery harness.
NOTE: The battery charger connector is factory installed on the RIGHT side of the wheelchair. It
can be positioned on either side of the wheelchair for user convenience.
NOTE: FOR RECLINERS ONLY: If the wheelchair is a recliner, the battery charger connector as
well as the limit switch, are factory set on the RIGHT side of the wheelchair. However, they can be
positioned on either side for user convenience. The limit switch MUST BE positioned on the same
side as the battery charger connector.
• TORQUE SP EQUIPPED WITH MARK IV RII JOYSTICK - Attach the battery
charger connector to the charger port on the FRONT of the joystick.
2. Plug the charger's AC power cord, or extension, into the grounded 120 VAC wall
outlet.
3G Storm Series® Wheelchairs
WARNING
118
Part No. 1104849

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Torque sp rwdRanger x rwd3g storm series

Table of Contents