Invacare Arrow RWD Service Manual page 123

4. Slide one connector battery box along the sub-frame and remove from the wheelchair.
5. Slide the two connector battery box along the sub-frame and remove from the
wheelchair.
Installing
1. Place the wheelchair in a well ventilated area where work can be performed without
risking damage to carpeting or floor covering.
2. Verify the joystick On/Off switch is in the Off position.
3. Secure the battery box carrying strap to the lid of the two connector battery box.
4. Place two connector battery box onto the battery sub-frame assembly with guide pins
facing the inside of the wheelchair.
5. Slide the two connector battery box along the sub-frame until its guide pins are
engaged in the sub-frame connector.
NOTE: Visually inspect to ensure the connection is properly made. Connectors MUST be fully
engaged.
NOTE: Make certain that the battery box carrying strap is positioned on top of the battery box and
will not interfere with the one battery box guide pins when engaging the connector on the one (1)
battery box lid.
6. Secure the battery box carrying strap to the lid of the one connector battery box.
7. Place one connector battery box onto battery sub-frame.
8. Slide one connector battery box along the sub-frame until its guide pins are engaged
in the connector of the two connector battery box.
NOTE: Visually inspect to ensure the connection is properly made. Connectors MUST be
fully engaged.
The battery box retainer MUST be locked securely to hold the battery boxes firmly
in place or battery box connectors may be damaged causing erratic
wheelchair operation.
9. Pull the battery box retainer down over the end of the one connector battery box until
it is securely clipped (locked) into place.
NOTE: 22NF To install the battery box onto the wheelchair, reverse the following procedure.
Part No. 1104849
CAUTION
123
SECTION 12—BATTERIES
3G Storm Series® Wheelchairs