Section 4-Safety Inspection/Troubleshooting; Safety Inspection Checklists - Invacare Arrow RWD Service Manual

SECTION 4—SAFETY INSPECTION/TROUBLESHOOTING
SECTION 4—SAFETY INSPECTION/
TROUBLESHOOTING

Safety Inspection Checklists

NOTE: Initial adjustments should be made to suit the end user's personal body structure needs
and preference. After initial setup, perform these procedures every time the wheelchair is serviced.
NOTE: Refer to the wheelchair service manuals listed in Reference Documents on page 2 for a
complete safety inspection checklist for the base.
All Wheelchairs
❑ Inspect for any loose hardware on seating system.
❑ Make sure all electrical connections are secure.
❑ Check that wiring is routed and secured properly to ensure that wiring does not
become entangled and damaged during normal operation of seating system.
❑ Make sure drive lock-out works properly.
❑ Check sensor position.
❑ Make sure tilt operates smoothly and properly.
❑ Make sure actuator mechanism and tilt tracks are clean.
❑ Ensure all fasteners are secure on clothing guards.
❑ Ensure arms are secure but easy to release.
❑ Ensure arm adjustment levers operate and lock securely.
❑ Ensure adjustable height arms operate and lock securely.
❑ Ensure arm pivot points are not worn and/or loose. Replace if necessary.
❑ Ensure seat and/or back upholstery have no rips and DO NOT sag.
❑ Ensure seat is secured to wheelchair frame.
❑ Ensure seat latch is functional. Replace if necessary (M71 and M91 Only).
❑ Inspect for rips in upholstery on armrests.
❑ Ensure armrest pad sits flush against arm tube.
❑ Inspect hand grips for looseness. If loose, have them replaced by a qualified
technician.
❑ Inspect seat positioning strap for any signs of wear. Ensure buckle latches. Verify
hardware that attaches strap to frame is secure and undamaged. Replace if necessary.
❑ Clean upholstery and armrests.
❑ Check that all labels are present and legible. Replace if necessary.
3G Storm Series® Wheelchairs
38
Part No. 1104849