Replacing Battery Charger Bracket And T-Nut - Invacare Arrow RWD Service Manual

Base Frame
NOTE: Before removing seat mounting plates, note the position of the washers.
3. Remove the seat support brackets. Refer to Replacing Seat Support Brackets on
page 86.
4. Remove the seat stop screw that is closest to the end cap. Refer to Removing/Installing
Seat Stop Screws on page 88.
5. Remove the end cap and channel cover.
6. Slide existing t-nut(s) out of channel.
7. Insert new t-nut(s) into channel in correct orientation.
8. Replace channel cover and end cap.
The seat stop screws must be in place before operation of your power wheelchair.
Ensure the t-nut(s) are positioned between both seat stop screws.
9. Use Loctite 242 and reinstall seat stop screw into base frame.
10. Reinstall the seat seat support brackets. Refer to Replacing Seat Support Brackets on
page 86.
11. Reinstall the seat mounting plates. Refer to Replacing Seat Mounting Plates on
page 85.
12. Adjust seat mounting plates to desired angle. Refer to Seat Angle Adjustment on
page 81.
13. Install the seat frame. Replacing the Seat Frame on page 66.

Replacing Battery Charger Bracket and T-Nut

NOTE: For this procedure, refer to FIGURE 10.4.
Part No. 1104849
Seat Support Bracket
FIGURE 10.3 Replacing Seat Support Brackets
WARNING
SECTION 10—BASE FRAME
T-Nut
87
Channel Cover
End Cap
3G Storm Series® Wheelchairs