Section 11-Retaining Strap; Replacing Battery Box Retaining Strap - 22Nf Battery Base Frames - Invacare 3G Storm Series Owner's Operator And Maintenance Manual

SECTION 11—RETAINING STRAP
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Replacing Battery Box Retaining Strap - 22NF Battery
Base Frames
NOTE: For this procedure, refer to FIGURE 11.1.
1. Remove the battery box. Refer to Removing/Installing the 22NF Battery Box on
page 106.
WARNING
The retaining strap MUST be fed
through the adjustable end of the bat-
tery box retaining strap clip as shown in
FIGURE 11.1.
2. Feed the battery box retaining strap
through the adjustable end of the
battery box retaining strap clip.
3. Feed the battery box retaining strap
through the slots in the battery box tray.
NOTE: The folded over portion of the retaining
strap stops at the slot. DO NOT try to force the
folded over section through the slot.
4. Install the new battery box retaining
strap by reversing STEPS 2 and 3.
5. Reinstall the battery box. Refer to
Removing/Installing the 22NF Battery
Box on page 106.
WARNING
The Battery Box Retaining Strap MUST
be fastened securely in place before
using the wheelchair.
Part No 1134791
All manuals and user guides at all-guides.com
WARNING
107
SECTION 11—RETAINING STRAP
Retaining Strap Clip
Retaining Strap
Slot
Battery Box
Tray
Folded Over Portion
NOTE: Tray shown by itself for clarity.
There is no need to remove the tray from the
wheelchair if the strap is being replaced.
FIGURE 11.1 Replacing Battery Box
Retaining Strap - 22NF Battery Base Frames
3G Storm Series® Wheelchairs
Retaining Strap
Slot
of Retaining Strap