3910-A2-GN32-40
5. Press the
key to place the SDCP in direct communication with the selected
Select
modem.
The LCD displays the Top-Level menu for the selected modem. In addition, the Front
Panel LED on the modem's faceplate and the OK LED on the SDCP light.
6. Once you have determined that the modem is installed properly and completed its
power-up self-test, rotate the circuit pack lock until it covers the faceplate latch
(Figure 2-3) and tighten the retention screw on the circuit pack lock. This prevents the
modem from accidently being removed once it is installed in a carrier.
7. Configure the modem as described in Selecting Factory Configuration Options on
page 2-6.
Figure 2-3. Circuit Pack Lock
September 1998
Modem Installation
2-11