Paradyne COMSPHERE 3911 Installation And Operation Manual page 211

S-Register
S61 CT111 Rate Control. Register determines if CT111 Rate is disabled,
set for Fallback 1 or Fallback 2.
CT111 Rate allows the DTE to control modem rate via Pin 23 of the
EIA-232-D interface. This configuration option determines the effect of
the DTE Rate Control signal. It is only valid in Async Direct mode and
Synchronous mode. For proper operation, disable the V.32bis Autorate
and V.32bis Automode configuration options.
Register has the following values:
0 = Disable
1 = Fallback
2 = Fallback 2
The factory setting is Disable.
S62 V.25bis Coding. Register identifies to the modem the type of coding
used by the DTE while in V.25bis mode.
Register has the following values:
0 = ASCII
1 = EBCDIC
The factory setting is ASCII.
S63 V.25bis Idle Character. Register identifies to the modem the type of
idle fill used by the DTE while in V.25bis mode.
Register has the following values:
0 = Mark
1 = Flag
The factory setting is Mark.
S64 V.25bis New Line Character. Register identifies to the modem the type
of line terminator used by the DTE while in V.25bis mode.
Register has the following values:
0 =Carriage Return and Line Feed
1 =Carriage Return
2 =Line Feed
The factory setting is carriage return and line feed (CR + LF).
S65 Line Current Disconnect. Register determines if the modem
disconnects if an 8-millisecond or 90-millisecond interruption in loop
current occurs.
Register has the following values:
0 = Enable (8msec)
1 = Enable (90msec)
2 = Disable
The factory setting is Enable (8msec).
3910-A2-GN32-40
Table 14-3
(7 of 13)
391x Series S-Registers
Description
September 1998
AT Command Set and S-Registers
DCP LCD
Command
Sequence
Configure\Edit\
DTE Interface
Configure\Edit\
DTE Dialer
Configure\Edit\
DTE Dialer
Configure\Edit\
DTE Dialer
Configure\Edit\
Line Dialer
14-21