Paradyne COMSPHERE 3911 Installation And Operation Manual page 213

S-Register
S72 RTS Antistreaming. Register determines the antistreaming operation
of the modem.
Register has the following values:
0 = Disable
1 = 10 sec
2 = 30 sec
3 = 1 min
4 = 2 min
5 = 3 min
6 = 5 min
The factory setting is Disable.
S74 Network Position Identification. Register identifies each modem as
either a control or tributary modem.
Register has the following values:
0 = Tributary
1 = Control
The factory setting is Tributary.
S75 Network Management Address. Register determines the modem's
network address. This address is used when accessing the modem
from the 6700 Series NMS.
Enter a value from 0 (network address 001) to 255 (network address
256). The factory setting is 0.
S76 V.32bis Autorate (Dial Line). Register determines if Autorating is used
on dial lines when connected in V.32bis mode.
Register has the following values:
0 = Enable
1 = Disable
The factory setting is Enable.
S78 V.32bis Automode (Dial Line). Register allows the modem (when
operating on dial lines) to automatically detect and connect to the
remote modem's modulation scheme.
Register has the following values:
0 = Enable
1 = Disable
The factory setting is Enable.
3910-A2-GN32-40
Table 14-3
(9 of 13)
391x Series S-Registers
Description
September 1998
AT Command Set and S-Registers
DCP LCD
Command
Sequence
Configure\Edit\
DTE Interface
Configure\Edit\
Misc
Configure\Edit\
Dial
Configure\Edit\
Dial Line
Configure\Edit\
Dial Line
14-23