Paradyne COMSPHERE 3911 Installation And Operation Manual page 167

Set Access Ctrl
Set Access Control allows you to configure critical parameters contained within the security
database table that control dial access security. These parameters are protected by an
Administrative Password, which is an 8-digit decimal number.
Set Access Control contains the Edit Password Table, Set Answer Security, Set Originate Security,
and Set Administrative Password security configuration groups. These groups do not appear on the
LCD until the correct Administrative Password is entered.
Admin Password?
The Administrative Password is an 8-digit decimal number password that allows only authorized
users to access Security branch functionality. This password must be entered every time you access
the Security branch. This feature ships from the factory with the Administrative Password set to
00000000.
Once the correct Administrative Password is entered, the Edit Password Table, Set Answer
Security, Set Originate Security, and Set Administrative Password groups can be displayed on the
LCD.
To enter your Administrative Password from Set_Access_Ctrl, make the following selections:
Select Set_Access_Ctrl from the Security branch.
The Administrative Password appears. This occurs every time you enter the Security branch.
Select the F2 ( " ) key to increment password values.
Press the
Continue this sequence until the full Administrative Password value appears and then select Ent.
If the correct value is entered, the EditPassWdTable group appears on the LCD.
3910-A2-GN32-40
Security >
Set_Acess_Ctrl
F1 F2 F3
Admin Password?
"00000000
Ent
F3
F1 F2
key to move the cursor to the next position.
Set Access Ctrl >
EditPassWdTable
F1 F2 F3
September 1998
Dial Access Security
12-5