Change Directory - Paradyne COMSPHERE 3911 Installation And Operation Manual

COMSPHERE 3900 Series Modems
To access Dial Standby or Return to Dial from the Call Setup branch, make the following
selections:
Press the
If the modem is operating in a Dial Backup mode, the Dial Standby function forces the modem
to primary leased lines and the LCD displays the status message Command Complete.
Once the modem is in Dial Standby mode, Return_to_Dial appears on the LCD. Selecting this
function forces the modem to the backup network and the LCD displays the status message
Command Complete.

Change Directory

Change Directory allows you to enter or modify telephone numbers. The modem has nonvolatile
memory locations that allow you to store up to 24 telephone numbers. Each directory location
can accept up to 40 characters; this includes the telephone number and dial command modifiers.
Any telephone number dialed using the DCP Dial command must appear in a directory location.
To access Change Directory from the Call Setup branch, make the following selections:
10-6
Call Setup:
Dial Standby
F1 F2 F3
key until Dial Standby or Return_to_Dial appears. Select the appropriate function.
Dial Standby
Command Complete
F1 F2 F3
If the modem is operating on leased lines and has a dial line
attached for dial backup purposes, it is required that directory
location 1 contain the telephone number used for dial backup.
Call Setup:
Change_Directory
F1 F2 F3
September 1998
NOTE
<
3910-A2-GN32-40