Make Busy/Remove Make Busy - Paradyne COMSPHERE 3911 Installation And Operation Manual

After selecting the desired interface, the message Command Complete appears on the bottom
line of the LCD and the selected interface appears in the xxxxx field.
To exit this function and remain in the Control branch, press the
the Top-Level menu, press the

Make Busy/Remove Make Busy

The Make Busy function forces the modem off-hook so it cannot answer a call. This is often
used with PBX systems to permit the busy out of a PBX port for rotary or hunt groups.
To access Make Busy from the Control branch, make the following selections:
Press the
The modem is now in a forced busy condition. Command Complete appears on the LCD.
3910-A2-GN32-40
key.
The Port1 interface is the only display allowed on the 3911 modem,
therefore, the entire EIA LEDs branch is masked.
To prevent violations of FCC and DOC regulations, this
function must only be used behind a user's PBX.
Control:
Make_Busy
F1 F2 F3
key until Make_Busy appears. Select Make Busy.
Make Busy
Command Complete
F3
F1 F2
September 1998
key. To exit and return to
NOTE
WARNING
Control Branch
7-5