Ae Inspection And Adjustment; Ae Accuracy Inspection And Adjustment; Built-In Sb Flash Inspection And Adjustment; Af Inspection And Adjustment - Nikon D60 Repair Manual

AE inspection and adjustment

(1) AE CCD alignment inspection and adjustment (ref. Page A28, A29 for details）

(2) AE accuracy inspection and adjustment

(3) Aperture accuracy inspection
(4) Adjustment for battery check level [Use the

(5) Built-in SB flash inspection and adjustment

〔Tools required〕ref. Page A33.
・AE accuracy inspection and adjustment
When AE accuracy inspection and adjustment is made, two types of lenses (AF50/1.4D, AF28/2.8D and
AF70-300/4-5.6D or AF-SVR70-300/4.5-5.6G) are used.
Caution:
AE accuracy is not inspected in the traditional manner that uses the exposure value of the shutter tester. The
metering value is displayed on PC screen.
・Battery check voltage level adjustment
Connect the Power connector (EP-5) of which the wire is processed to the camera. Then make adjustment.
・Built-in SB flash inspection and adjustment
Set the distance between camera and flash meter to 1 m, and inspect and adjust the light volume of the built-in
SB. (ref. adjustment software for details)

AF inspection and adjustment

Note: When the adjustment software is used for the first time, prepare three D60 cameras and measure by
"WRITING of AF ADJ. LENS OFFSET VALUE" on the main menu. If "LDATA.DAT"of D40(D40X)
is obtained under the same environment, copy it into a folder of D60 adjustment software, and change
"D40(D40X)" to "D60" of the file name "D40LDATA" to become usable.
(1) AF accuracy adjustment (Make the overall following adjustment.)
(2) YAW, PITCH inspection and adjustment
(3) LARK adjustment (inc. CCD output adjustment)
(4) AF shift adjustment
〔Tools required〕
1. In common with all adjustment/inspection items
ref. Page A33.
2. When inspecting AF accuracy
(1) AF adjustment Z lens (J18266)
(2) AF adjusting tool (J15259）
(3) Lens holder (J15280)
(4) AF accuracy measuring chart D40 (J18415), Chart board (J15409)
(5) Chart illuminator for AF（J15264）
3. When adjusting YAW, PITCH
YAW, PITCH tool（J18230）
4. When adjusting LARK
The above tool when inspecting AF accuracy
In "AF shift adjustment", the distance from the bayonet reference plane to the imaging area (CCD) is calculated
by the actual shot photo, and its error is recorded in EEPROM as compensation amount, and adjusted.
EP-5 and stabilized power supply.]
Power connector
- Ａ  ･ -
logo_Q0650_forGraphic
071004_Gdesign_ito
INC
VBA21001-R.3753.A