Ae Inspection And Adjustment; Ae Accuracy Inspection And Adjustment; Battery Check Voltage Level Adjustment; Af Inspection And Adjustment - Nikon D300 Repair Manual

AE inspection and adjustment

① AE CCD alignment inspection and adjustment (ref. Page A27 and 28 for details）

② AE accuracy inspection and adjustment

③ Aperture accuracy inspection
④ �uilt�in S� flash inspection and adjustment
⑤ Adjustment for battery check level (Use MB-D10 and stabilized power supply.）
〔Tools required〕ref. Page A26.
・AE accuracy inspection and adjustment
When AE accuracy inspection and adjustment are made,
The following types of lens (A�50/1.4D, A�28/2.8D, A�70-300/4-5.6D or A�-SVR70-300/4-5.6) are used.
Caution:
AE accuracy is not inspected by using the e�posure value of the traditional shutter tester. The metering value
is displayed on PC screen.
When AE sensor reference values are obtained,set the metering mode to "multi-pattern".
・Battery check voltage level adjustment
Connect MB-D10 to the camera for the adjustment.
・�uilt�in S� flash inspection and adjustment
Set the distance between camera and flash meter to 1 m, and inspect and adjust the light volume of the built�in
SB. (ref. adjustment software for details)
A� inspection and adjustment
Note: When using the adjustment software for the first time, prepare three cameras of D3�� and measure by
"WRITI�G of A� ADJ. LE�S O��SET VALUE" on the main menu.
① A� accuracy adjustment (Make the overall following adjustment.)
② YAW, PITCH inspection and adjustment
③ X/Y inspection and adjustment
④ LARK adjustment (inc. CCD output adjustment)
⑤ A� shift adjustment
〔Tools required〕
・When adjusting for all adjustment items
ref. Page A26.
1．When inspecting A� accuracy
① A� adjustment lens (J18266)
② A� adjusting tool (J15259）
③ Lens holder for �4 (J15280)
④ A� chart (J18344）
⑤ Chart illuminator for A� (J15264)
2．When adjusting YAW, PITCH
YAW, PITCH tool (J18230)
3．When inspecting/adjusting X/Y
A� X/Y chart (J63101)
4．When adjusting LARK
The above tool when inspecting A� accuracy
5．A� shift adjustment
The distance from the bayonet reference plane to the imaging area (CCD) is calculated by the actual shot photo,
and its error is recorded in EEPROM as compensation amount, and adjusted.
《USB connection communication》
《USB connection communication》
《USB connection communication》
《USB connection communication》
- Ａ  ・
《USB connection communication》
《RS232C connection communication》
-
logo Q0310 forGraphic
070509 Gdesign ito
INC
VBA20001-R.3720.A