Necessary Adjustments When Parts Are Replaced; D60 Adjustment Items And Firmware Updates - Nikon D60 Repair Manual

Necessary adjustments when parts are replaced

1. D60 adjustment items and Firmware updates

Writing of
Adjustments
Replacement parts
Shutter unit
＊ 
TOGO PCB unit
（MAIN&RISC
Firmware,register)
LOFT PCB
(Sub MCU mounted)
＊ 
Relay-PCB
（EEPROM）
AF sensor unit
Top cover or
SB lower case unit
DC/DC PCB
AE FPC unit
Aperture control
PCB unit
Eye sensor FPC
Rear FPC
＊ 1. Make inspection.
＊ 2. ・When only TOGO PCB unit is replaced, be sure to update the MAIN&RISC firmware.
・When both TOGO PCB and relay-PCB are replaced at the same time, write the fixed values and update the MAIN
&RISC firmware. Then, write the fixed values again and make adjustment.
Caution: If the MAIN firmware named (A60******.bin) is not recognized, change the firmware name to
(A650******.bin), and update again.
If the RISC firmware named (B60****.BIN) is not recognized, change the firmware name to
(B650****.BIN), and update again.
AE
AE CCD
EEPROM accuracy
positioning
fixed inspection &
adjustment
values adjustment
＊ 
○ △ ○
＊ 
○ △ ○
○ ○
- Ａ  ･
Aperture Battery Built-in SB
accuracy check volt- light volume
inspection age level inspection &
adjustment adjustment
○ ○ ○
○ ○ ○
○
○ ○
○
-
logo_Q0650_forGraphic
071004_Gdesign_ito
INC
VBA21001-R.3753.A
AF Eye sensor
accuracy inspection
inspection & and adjust-
adjustment ment
○ ○
○
○ ○
○
○
○